How to connect Genymotion SaaS virtual devices to ADB?

In order to connect a Cloud SaaS device to ADB, you first need gmsaas tool:

1. Install gmsaas tool. For instructions, please refer to gmsaas tool userguide.
2. Set gmsaas to use ADB from your SDK tool by using:

   gmsaas config set android-sdk-path <sdk_path>

   Where <sdk_path> is the full path to your SDK tool (for exemple /home/your_username/Android/Sdk)

   Important

   gmsaas does not support relative paths. For example: sdktools/ or ./sdktools will not work.

3. Connect your running device(s) using this command:

   gmsaas instances adbconnect [--adb-serial-port PORT] <instance_uuid>

4. To verify, run command adb devices.
   If your device is properly connected, it should return localhost:XXXX devicefor each connected device.

If you get the error message Adb tunnel communication failure it is probable that:

• the <sdk_path> has not been set properly. Verify the path and try section 2 again.
• your firewall/network blocks adb default port. Use option --adb-serial-port PORT with an open port option in this case.
• adb default port is unavailable. Use option --adb-serial-port PORT with an uvailable port.